Factors to Consider When Looking at Plotter Blades
If you are working with a vinyl plotter then it is important that it will be efficient. Achieving this one can be done once you are able to choose the right plotter bade. One of the things that you need to look into is the angle of the blade. The angle of the blade should be changed depending on the media that you are working. This is done to optimize the quality of the cut. You also need to remember that the angle of the blade will vary from one manufacturer to the other. The most common ones that you can see on the market are the 30, 45 and 60-degree angles.
The sharpest angle and has more cutting surface on the blade is the 60 degrees type. You will find this one ideal once you will be working on thicker materials. See to it that when looking at the angel of the blades to opt for the one that is able to cut through the material and adhesive. Once you will choose a blade that is high enough then it is the one that can help you avoid vinyl ears causing a poor quality cut.
If you are working on a material that is about 1-2 mil range then it is the 30 degrees blade that you should be utilizing. IT is the 45 degrees blades that you should be utilized once the materials are 2 mil up to around 5 or 6 mil. Once you will be working on films are thicker than 6 mil then the best option that you can have is to opt for the blades with a 60 degrees angle. Once you take a look at the market then you will see film brands that work great on particular blade angles. The 45 degrees angled blades are also great especially if you switch a lot between 2 mil cast films and 3-4 mil calendered films. Whenever it is this one is what you will be choosing to have then you can get a good all-purpose blade for everyday use.
Once you have already chosen the blade then you will need to make manual adjustments on it. It is the blade that should protrude from the baked holder just right. Exposing too much of the bake is a thing that you don’t want to do. It is the blade that should be exposed at around of the thickness of a credit card. It is the pressure that you will need to adjust next once the blade is in place. It is you that can choose to follow the default settings recommended by the cutter manufacturer and start adjusting from there.